Menu

RCDT310, RCDT320 and RCDT330

Residual current device testers

  • Tests standard, DC and selective RCDs
  • Ramp testing
  • Auto (Remote) testing
  • 3 Phase safe
  • Enables testing on 110 V centre tapped supplies.
  • Tough rubber armoured case with built-in cover
  • Weatherproof to IP54

MEGGER BOOSTS SAFETY IN RCD TESTING

Even if they are inadvertently connected to a live three-phase supply, RCD testers in Megger’s RCDT300 range remain undamaged, and present no safety hazard to the user. Introduced after extensive customer research into the requirements of electrical contractors, these innovative instruments combine rugged construction with straightforward operation, and they are offered at very competitive prices.

Available in three models RCDT300 RCD testers feature a compact design, making them easy to  use, and tough with a rubber overmoulding for additional protection, plus a built-in display cover. All models in the range are water and dust resistant, with an IP54 rating.

RCDT310 model is suitable for use on supplies between 100 V and 280 V, and offers 0.5I, I and 5I tests, with provision for tests starting at 0° or 180° of the supply waveform, as well as for DC tests. It also has facilities for testing standard and selective RCDs, and covers current ranges from 30mA to 500mA. When connected to a live supply, it defaults to voltmeter mode.

RCDT320 covers a wider supply voltage range of 50 V to 280 V, allowing use with centre-tapped 110 V supplies. It incorporates ramp testing, for RCD tripping current measurement, and the unique Megger auto sequence test feature, which saves time by allowing the tester to conduct all the RCD tests, and to store the results while the operator stands by the RCD, resetting it as appropriate.

RCDT320 has an extended operating current range to cover 10 mA to 1,000 mA devices, and the ability to measure AC supply voltage and frequency is added. The large liquid crystal display for test results is backlit in this model, making it easier to use in locations with low ambient light levels.

The RCDT330 additionally offers the facility to save test results to internal memory. Over 1000 result can be saved on site, and downloaded to a computer when convenient.

Data is stored in non-volatile memory, being retained when the instrument is switched off or batteries are exhausted.

Find out about FormFiller a FREE certification for BS7671 Electrical compliance package by clicking here.

All models in the range comply fully with the requirements of IEC61010-1 for Category III 300 V applications, and are supplied complete with appropriate test leads and a calibration certificate.

Product Documents
Data sheet
Data sheet - RCDT300
User guide
User guide - RCDT300