Menu

EZ-THUMP 3 kV and EZ-THUMP 4 kV

Highly portable fault location systems for LV networks

  • Dual stage 500 J surge energy at 1.5 kV and 3.0 kV EZ-Thump 3kV only
  • Single stage 500 J surge energy at 4.0 kV EZ-Thump 4kV only
  • F-OHM HV interlock to ensure safe earthing
  • Battery and AC line operation
  • Automatic end-of-cable and fault locating
  • Transflective color display
  • ARM® Prelocation
  • Fault Pinpointing (Thumping)
  • Optional Sectionalizing Software*

Weighing as little as 32 kg the EZ-Thump 3 kV is the first of its kind in the market and with updated EZ-Thump 4 kV this series are the most portable fault location systems specifically for shielded and unshielded low voltage power cable.

They use the “Easy Go” test system, which is easy to operate, interprets the results and requires minimal training to find faults. On-board is a TDR with a 7.6 km range and arc reflection at 3 or 4 kV respectively for pre-locating. For pinpointing, EZ-Thump offers a surge energy of 500 J, at 1.5 and 3 kV or 4 kV respectively,  d.c. testing for breakdown detection and insulation resistance measurement.

An additional application for the EZ-Thumps is sheath fault testing as well as sheath fault location.

The units can be operated from line or their internal battery. They can fit in the boot of a car, making them ideal for a flexible rapid response fault finding strategy.

Product Documents
Data sheet
Data sheet - EZ-Thump 3 kV and EZ-Thump 4 kV
E-Tray Software

ETRAY SOFTWARE UPDATE NOTICE

APPLIES TO: T3090, EZ-RESTORE, EZ-THUMP AND SMART-THUMP

SOFTWARE UPDATE WARNING:

Prior to updating the affected products to software version 2.5.2/0.43 or later, you must first consult the factory via the contact information provided below to determine if your instrument hardware can support the upgrade. Failure to consult the factory prior to performing software upgrades could leave your instrument in a state that will require it to be sent in for repair.

Please have the following information ready before you call:

Contact Us

Customer Service: 1-800-723-2861

ETray Demo for PC (Windows 7 64-bit)
ETrayDemo v2.6.1.7 25Oct2017.zip File Size: 8.3MB File Date/Revision: 2.6.1.7 SHA1: 8797eff2581d06dbafa83efd85a23d63c2e2f8ac
ETrayDemo-v2-6-1-7-25Oct2017.zip
8.0 MB | 12/12/17
E-Tray Product Update Documentation
Software release note detailing changes in E-Tray Software Update
E-TRAY-SW-PRODUCT-UPDATE-2-5-1FW0-40.pdf
166.6 KB | 12/12/17
ETray Software
ETrayUpdate 2.6.1.7 FW 0.48.zip This is the software for use in the following products: • EZ-Thump • EZ-Restore Overdrive • Smart-Thump • T3090 File Size: 1.2MB File Date/Revision: Software Update 2.6.1.7 / Firmware 0.48 SHA1: 651b35d8f8e33c341cf8698aac8bf36206c2f6e7
ETrayUpdate-2-6-1-7-FW-0-48-111417.zip
1.2 MB | 12/12/17